Home / News

By ConnectME | Published Nov 3, 2026 | Coverage: Oct 25, 2026

SEWA Commissions Two Substations as Sharjah Load Grows

SEWA commissioned two 33 kV substations and reported work on 15 more. For building owners, the practical question is whether planned electrical loads are backed by credible demand data.

Generated illustration of an engineer reviewing electrical substation equipment; not a SEWA facility or project photograph

New network capacity and a building's own load plan are different parts of the same conversation. The Sharjah Electricity, Water and Gas Authority (SEWA) has commissioned two 33 kV distribution substations, according to an Emirates News Agency report dated 25 October 2026. One operates under an advanced pilot system; the other is the first phase of the Industrial Area 3 "A" substation. WAM says its second phase was approximately 95% complete when reported.

What the announcement covers

SEWA also reported work underway on 15 substations rated 33/11 kV, with four of those scheduled for completion in 2026. The stated purpose is to support network reliability and growing demand as Sharjah expands. These are network projects. The announcement does not establish available capacity at any particular plot, promise a connection date for a development, or quantify an improvement in outage performance.

The decision for owners and developers

Before a new connection, major retrofit or tenant expansion, ask whether the project's electrical-load schedule matches measured and forecast demand. Separate the loads already operating from those planned for later phases. Identify where whole-building, common-area and tenant electricity readings will be captured, and who will reconcile them after commissioning.

  • Record peak demand and the operating conditions behind it, rather than relying only on annual energy totals.
  • Show staged loads, equipment start-up assumptions and any planned backup or on-site generation separately.
  • Specify electricity-meter boundaries and a repeatable validation process so later expansion decisions use dependable readings.

These are ConnectME's planning questions, not SEWA requirements. The utility's substation programme illustrates why owners should bring a credible load and metering picture to capacity discussions, without assuming that network expansion alone resolves a building's internal electrical constraints.

Source context: project status, voltages and the stated network purpose are from WAM's 25 October 2026 report. ConnectME's building-level interpretation was published 3 November 2026. The generated image is illustrative, not a photograph of a SEWA site.

Related Application Solutions

  • Protocol Converters and Gateways UAE: Protocol converters and gateways in UAE for BACnet gateway, Modbus gateway, M-Bus gateway, MQTT gateway, IoT gateway, edge gateway, and BMS integration.
  • Smart Valves and M-Bus Shutoff UAE: Smart M-Bus shutoff valves and controllers for UAE utility projects, with battery operation, remote control, AMR integration, and tenant billing workflows.
  • Utility Billing Software UAE: Utility billing software and tenant billing automation for UAE buildings, communities, malls, hotels, and commercial portfolios with AMR and MDMS integration.
  • Energy Management System UAE: Monitor electricity, cooling and water across UAE buildings with meter integration, data checks and EMS dashboards. Compare assets and verify energy improvements.